Tempaper Swell Peel & Stick Wallpaper

$65.00

Peel-and-stick vinyl.
Easy to install and remove.
Install with our Peel & Stick Install Kit (sold separately).
Recommended for smooth surfaces that are in good condition.
Installation instructions included with purchase.
To calculate the number of rolls you need: 1) Measure the height and the width of your space in inches; 2) Multiply the two numbers; 3) Divide the sum by 144; 4) Divide by coverage per roll (i.e., number of square feet covered per roll); 5) Multiply by 1.15 (to ensure sufficient supply for pattern alignment and potential mistakes); 6) Round up to the full roll.

DETAILED SPECIFICATIONS

ASSEMBLY INSTRUCTIONS

Recommended for smooth surfaces that are in good condition and have been primed and painted with an eggshell, satin or semi-gloss finish. Applications on flat and matte paints and textured surfaces are not recommended.
Using a level, mark a vertical guide down the length of surface.
Place your roll on a soft surface, such as a bath mat or towel, at the bottom edge of starting point.
Pull paper up from roll to meet the top edge of surface.
Peel back 3-4 ft. of the backing.
Begin at the top edge aligning paper with your vertical guide to ensure a straight application.
Use a squeegee to smooth paper to surface working from the center out. Tempaper can be repositioned as needed to ensure pattern alignment and to eliminate bubbling.
Continue in 3-4 foot increments peeling and smoothing until you reach the bottom edge of your surface allowing paper to overhang by 2-3 inches and cut paper from roll.
Repeat steps making sure to align pattern with each consecutive panel until the surface has been fully covered.
Trim where needed with a craft knife to complete your application.
To remove: Starting with any corner, firmly peel up or down slowly parallel to the surface.

CARE

Wipe clean with damp cloth.

Your cart is empty