Tempaper Feather Palm Peel & Stick Wallpaper

Overview

KEY DETAILS

• 20.5"w x 198"l.
• Peel-and-stick vinyl.
• Easy to install and remove.
• Recommended for smooth surfaces that are in good condition.
• Covers 28 sq. ft.
• To calculate the number of rolls you need: 1) Measure the height and the width of your space in inches; 2) Multiply the two numbers; 3) Divide the sum by 144; 4) Divide by coverage per roll (i.e., number of square feet covered per roll); 5) Multiply by 1.15 (to ensure sufficient supply for pattern alignment and potential mistakes); 6) Round up to the full roll.

Details + Dimensions

DETAILED SPECIFICATIONS

• Roll measurements: 198"l x 20.5"w
• Each roll covers approximately 28'sq. of wall space.

INSTALLATION

• Recommended for smooth surfaces that are in good condition and have been primed and painted with an eggshell, satin or semi-gloss finish. Applications on flat and matte paints and textured surfaces are not recommended.
• Using a level, mark a vertical guide down the length of surface.
• Place your roll on a soft surface, such as a bath mat or towel, at the bottom edge of starting point.
• Pull paper up from roll to meet the top edge of surface.
• Peel back 3-4 ft. of the backing.
• Begin at the top edge aligning paper with your vertical guide to ensure a straight application.
• Use a squeegee to smooth paper to surface working from the center out. Tempaper can be repositioned as needed to ensure pattern alignment and to eliminate bubbling.
• Continue in 3-4 foot increments peeling and smoothing until you reach the bottom edge of your surface allowing paper to overhang by 2-3 inches and cut paper from roll.
• Repeat steps making sure to align pattern with each consecutive panel until the surface has been fully covered.
• Trim where needed with a craft knife to complete your application.

REMOVAL

Starting with any corner, firmly peel up or down slowly parallel to the surface.

CARE

Wipe clean with damp cloth.